PremiumLift AirCare Max-Pro ACMaxPP, User Manual, Page: 14 / 27

14
www.premiumlift.com.au
INFLATING THE MATTRESS/CUSHION
1 Plug in at the mains supply, press the ON button on the side of the pump and then
on the control panel. The control panel will light up to indicate that there is a power
supply.
2
The pump is in start up mode. Once the mattress is fully inflated it will be ready to use.
While in start up mode do not select static mode. This will cause the pump to
alarm. If the pump alarms, switch off the pump and switch it back on to reinflate the
mattress.
The mattress is now ready to be used.
Set the pump to run at the correct pressure to suit the weight of the
service user. Refer to the Pump Control Panel guide on the front of
the pump.
To turn off the system press the power button to
OFF and unplug from
the mains supply.
TRANSPORT MODE
If the pump needs to be disconnected for any reason attach the transport cap to the feed
tubes connector. This will prevent deflation retaining the remaining air within the mattress.
The alternating action stops in this mode.
SETTING UP PROCEDURE
It is important to follow the correct setting up procedure to ensure the patient receives
sufficient support whilst achieving maximum pressure relief and comfort.
Failure to follow this procedure could result in the patient being put at risk.
1
When the mattress is fully inflated set the pump to the approximate weight of the
service user. Position the service user in the lying position. If required adjust the weight
setting to meet the patient’s comfort needs.
2 Ensure that the comfort setting is altered correctly when the patient moves from a lying
to a sitting position and vice versa.
NOTE: The static mode is only to be used for patient care. Switch off after use.
OPERATION