Connect to power source, press the ON/OFF switch. The heating indicator (red) will be
illuminated.
4. Turn the knob to the “
” position, the pump will pump water. When there is water
flowing out, close the pump by turning the knob again to the “ ” position, make sure the
steam button is on the higher position which is the “
” position and wait for a moment. The
appliance begins to pre-heat until the ready indicator (blue) is illuminated to show the
pre-heating is finished. Turn the knob to the “
” position again, and water will flow out.
5. After about one minute, turn the knob to the “ ” position to stop brewing. You can pour
out the water left in each container, and then clean them thoroughly. Now you can start
brewing coffee.
PRE-HEATING
To make a cup of good hot espresso coffee, we recommend you preheating the
appliance before making coffee, including the funnel, filter and cup, so that the coffee
taste will not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill it with water. The water
level should not exceed the “MAX” mark in the tank. Then place the tank into the
appliance properly.
2. Set the steel mesh into the metal funnel, making sure the tube on the funnel aligns with
the groove in the appliance, then insert the funnel into the appliance as indicated on
the “INSERT” mark, and fix them into the coffee maker firmly turning them
anticlockwise until fully locked.
3. Place an espresso cup (your cup – not provided) on removable drip plate.
4. Connect the appliance to the power supply source. Make sure the knob is on the “ ”
position.
5. Press the
ON/OFF
switch, the heating indicator (red) will be illuminated. Make sure the
steam button is on the higher position which is the
“
”
position. Turn the knob to the
“
” position, when there is water flowing out, close the pump immediately by turning
knob again to the “ ” position
.
The purpose of the step is that pump the water of the
tank into the housing.
