PDS-PLUS/PDS-PLUS-W
Installation Instructions
Visit the Premier Mounts website at http://www.mounts.com
Page 11
1)
Identify the projector’s approximate front-to-back
center of gravity. Place your hands on each side of
the projector and gently lift it an inch from the surface
on which it is resting. Carefully adjust your grip on the
projector until it seems balanced from front-to-back.
Mentally note the apparent center of gravity.
2)
Identify the projector’s approximate side-to-side
center of gravity. Place your hands on the front and
back of the projector and gently lift it an inch from the
surface on which it is resting. Carefully adjust your
grip on the projector until it seems balanced from
side-to-side. Mentally note the apparent center of
gravity.
3) Place the PDS-PLUS/PDS-PLUS-W Projector Plate
(if not already attached) on top of the mounting legs
with the center of the plate as close as possible to the
projector’s center of gravity.
Step 4
Side-to-Side
Center of Gravity
Front-to-Back
Center of Gravity
Step 5
1)
Position the legs accordingly for best configuration.
You may raise or lower each leg independently by
turning the leveling barrels.
2)
Secure the legs to the projector plate by screwing
Knurl knobs into the M6 square nut (do not
overtighten) on the mounting legs.
3)
Verify the position of the integrated sliding M6 square
nut in the mounting leg relative to a nearby slot on the
PDS-PLUS/PDS-PLUS-W Projector Plate.
If the M6 square nut is not aligned with any slot, you
can use any thin implement, such as a toothpick, to
nudge it into alignment.
Sliding M6
Square Nut
Step 6
1) Tighten the mounting screws which secure the
mounting legs to the projector.
Do not overtighten the mounting screws.
