PDS-PLUS/PDS-PLUS-W
Page 10
Visit the Premier Mounts website at http://www.mounts.com
Installation Instructions
Step 2
1)
Attach the appropriate number of mounting legs to the
projector using the corresponding mounting hardware.
Do not tighten the mounting hardware at this time.
Step 3
1)
If the mounting legs need to be leveled, rotate the
leveling barrels to level the mounting bracket.
2)
To raise the mounting legs, rotate the leveling barrel
clock-wise. To lower the mounting leg, rotate the
leveling barrel counter clock-wise.
Raise or lower each of the mounting legs, by
rotating the leveling barrels, until all of the mounting
legs are at an equal height.
•
Lower the mounting leg by rotating the leveling
barrel counter-clockwise.
•
Raise the mounting legs by rotating the leveling
barrel clockwise.
3)
When the desired position is achieved, tighten the
mounting screws to the projector and then tighten the
hex head leg screws with the M5 Allen wrench.
Mounting Hardware Too Long?
The depth of some projector mount points may
prevent you from tightening the M2.5 and M3
mounting hardware.
You can reduce the length of the M2.5 and
M3 mounting hardware by stacking up to a
maximum of five (5) M3 flat washers inside the
leveling barrel.
Avoid stacking too many M3 washers; the
mounting hardware must thread into the
projector mount point at least four (4) complete
turns.
Only attach to the projector manufacturer’s
specified mounting points on the projector chassis
with a minimum three mounting legs. Please follow
all safety instructions specified by the projector
manufacturer as well as the safety instructions
outlined in this manual.
Depending on your application, the long mounting
legs and the short mounting legs may be used
together. There are multiple configurations that may
be used combining the long mounting legs with the
short mounting legs.