15. Use four bolts (A) and four locknuts (E) from the hardware
kit to secure the seat to the mid-column support bar. Refer
to Diagram 3 and take the following steps:
a.
Unpack the seat (if you have not already done so) and
lift it onto the mid-column support bar. Align the seat
base support with the bolt hole mounts and insert the
bolts through the mounting holes.
Note: The head of the bolts should be on the outside
of the seat base support.
b.
Screw the bolts into the bolt hole mounts so that you
can place a locknut on the end of each bolt.
c.
Attach the locknuts to the end of the bolts by carefully
moving your hand through the front opening of the seat
base support and placing a locknut on the end of each
bolt.
CAUTION: Some sections on the inside of the seat
base support can be sharp so remove your hand
slowly and carefully once you have attached and
finger-tightened the locknuts to the bolts.
16. Tighten the bolts securely. To do this, grasp the box
wrench (F) in one hand and carefully re-insert your hand
in-between the seat base supports. Hold onto each locknut
with the box wrench as you tighten its corresponding bolt
using the hex key (C) provided. Alternate between each
bolt until all four bolts are tightened securely. Do not
overtighten.
Refer to steps 17 and 18 in your
Owner’s Manual to complete
the assembly process.
P/N 36298-102
1/94
Diagram 3
Installing the seat
Seat
Rear support
Mid-column support bar
Adjustment handle
Bolt hole mounts
Seat base support
