Precor Discovery DSL0314, Assembly Manual

Page: 63 / 68

Diverging Lat Pulldown Assembly Guide: Routing the Cable Assembly 13
3. Using a
³₄
-inch socket wrench and a
³₄
-inch open-end wrench, remove the
nut and cable retainer on the second pulley.
Figure 19: Cable retainer removal
4. Thread the cable over the pulley and replace the cable retainer, making
sure that the cable is positioned in the pulley groove and under the cable
retainer. Using a
³₄
-inch socket wrench and a
³₄
-inch open-end wrench,
tighten the nut to 500 in-lb (56 N-m) of torque.
5. Thread the cable down through the opening under the second pulley, as
shown in the following figure.
Figure 20: Cable route down through weight tower frame