Precor Discovery DSL0314, Assembly Manual

Page: 52 / 68

Diverging Lat Pulldown Assembly Guide: Getting Started 2
Assembly of each piece of Discovery Selectorized equipment takes about 30
minutes. If this is your first time assembling this equipment, allow more time.
Installation Requirements
WARNING
You will need assistance to assemble this unit. DO
NOT attempt assembly by yourself .
Follow these installation requirements when assembling the unit:
 Assemble the unit near the place where you plan to use it.
 Locate the equipment at least 40 inches (1 meter) away from walls or
furniture on either side of the equipment, and 40 inches (1 meter) away
from objects behind the equipment.
 Set up the unit on a solid, flat surface, so that it remains level and stable. A
level unit has fewer malfunctions.
 Open the box and assemble the components in the sequence presented in
this guide.
 Insert, align, and thread all fasteners with your fingers. This helps prevent
cross-threading. Do not wrench tighten fasteners until instructed to do so.
Important: Before you wrench tighten a fastener, check that its head is flush
with the surface of the product. If not, cross-threading may have occurred. Do
not attempt to rework the assembly as more damage to the equipment will
occur. Instead, contact Customer Support as described in Obtaining Service.
 If you plan to move the unit, get help and use a hand truck.
Required Tools
 Torque wrench that can be fitted with the following hex bits:

⁷₃₂
-inch hex bit

⁵₁₆
-inch hex bit

⁵₃₂
-inch hex bit

¹₂
-inch hex bit

³₈
-inch hex bit
 #2 Phillips bit
 Socket wrench that can be fitted with the following sockets:

⁹₁₆
-inch socket
 1-inch socket

³₄
-inch socket

⁹₁₆
-inch socket

³₄
-inch open-end wrench

⁵₃₂
-inch hex wrench
Getting Started