Precor Discovery DSL0314, Assembly Manual

Page: 55 / 68

Diverging Lat Pulldown Assembly Guide: Assembling the Equipment 5
3. Slide the base and cross supports into the fittings on the movement frame
and secure them using the fasteners previously removed.
Important: Do not fully tighten the fasteners. These will be tightened once the
tower is connected to the equipment.
Figure 4: Cross and base support attachments
To attach the Diverging Lat Pulldown to the weight tower:
1. Locate the point where the base support attaches to the weight tower.
Using a
⁷₃₂
-inch hex bit and a
⁹₁₆
-inch socket, remove the two bolts, four
washers, and two nuts installed there and set them aside.
2. Locate the point where the cross support attaches to the weight tower.
Using a
⁵₁₆
-inch hex bit and a 1-inch socket, remove the four bolts and two
domed washers.
3. Attach the base support to the weight tower using the fasteners removed
previously. Partially tighten the fasteners.
Figure 5: Base support attachment to weight tower