C534i Elliptical Fitness Crosstrainer
Page 48
9.
Set the replacement generator at its mounting position. Remove the three generator
mounting screws, the three bearing clamp screws and the bearing clamp. Lift the generator
and place the drive belt around the generator’s pulley.
Diagram 7.8 - Generator Mounting, Pulley Side
10. Replace and tighten the three generator mounting screws removed in step 9. Set the
bearing clamp in its mounting position, replace and tighten the three bearing clamp
mounting screws removed in step 9.
11. Hand start, but do not tighten the four mounting nuts removed in step 6. The generator must
be able to move in order to adjust the belt tension.
12. Adjust the generator drive belt tension per Procedure 5.3.
13. Reconnect the red battery lead removed in step 1 and replace the rear cover.
14. Check the operation of the EFX as described in Section Four.
Mounting Screws
