9
Rewire the AMT for a touchscreen console
DANGER
DO NOT attempt to connect electrical power until all assembly
procedures are complete and the console is properly installed.
Retrieve the following parts from the console package:
TV (coax) coupler
Ethernet (CAT 5) coupler and cable
Cable, and the console power cable
Important
Make sure all cables pass through all of the cable clips and DO NOT allow
any of the cables to hang near moving parts.
Note
In the following steps, pass the console power cable through the opening first,
followed by the TV cable. Pass the remaining cables through in order of connector
size (see Figure 11).
Figure 11
Thread the cables for each part as follows:
1.
TV connection
:
a.
Install the TV (coax) coupler, star washer, and nut, into the jack plate at the
lower end of the AMT and tighten (see Figure 12).
b.
Connect the TV cable to the inside end of the TV cable coupler. Tighten the
connector using a 7/16-inch open-end wrench.
2.
Ethernet connection
:
a.
Attach the Ethernet coupler into the jack plate at the lower front of the AMT
(see Figure 12).
b.
Plug the Ethernet cable into the coupler.
3.
Console connection
:
a.
Plug the console power cable into the jack plate (see Figure 12).
b.
Slide the quick-disconnect terminal on the grounding lead of the power cable
over the grounding terminal on the equipment frame.
Figure 12
Summary of Contents for AMT 885
