Precor AMT 885, Assembly Manual, Page: 19 / 45

12
Position the handlebars
During shipment, the AMT is packed with its handlebars reversed. Two set screws
are threaded into each handlebar. The plastic boots that eventually cover the screws
are positioned just above them on the handlebars.
To position the handlebars for use:
1. Remove the two set screws from one handlebar (see Figure 17).
Figure 17
2. Rotate the handlebar exactly one half turn (180°) (see Figure 18).
Note When the handlebar is positioned correctly, it bends slightly outward.
The screw holes in the handlebar should also line up with those on the AMT
frame.
Figure 18
3.
Reinsert the two set screws. Leave the screws partially tightened until you have
adjusted both handlebars.
4. Repeat Steps 1 through 3 to position the other handlebar.
5. Adjust the positions of both handlebars outward as much as possible. Both
handlebars should be at equal angles to the body of the AMT and angled slightly
outward (see Figure 19).
Figure 19
6. Rotate one of the plastic boots so that it aligns with the surface below it, then
press the boot downward to secure it in place (see Figure 20). Repeat this step
to position the other plastic boot.
Figure 20