Precor AMT 885, Assembly Manual

Page: 44 / 45

Clean the running belt and deck (treadmill only)
Before you begin the cleaning procedure, check that the safety stop key works correctly.
CAUTION DO NOT stand or allow others to stand on the treadmill running belt during this procedure.
To make sure the safety stop key works:
1. Stand to one side of the treadmill.
2. Make sure that the stop key lanyard is hanging straight down and is not wrapped around the handle bars.
3. Press Quick Start and wait for the running belt to begin moving.
4. Press the safety stop key.
5. The running belt should stop immediately. When it stops, reset the safety stop key.
CAUTION If the running belt does not stop, turn off the treadmill power using the On/Off switch at the front of the
treadmill and unplug the power cord. The treadmill must remain out of service until the stop switch is repaired.
Place an "out of order" sign on the treadmill and contact Precor Customer Support.
6. Turn the treadmill power switch to Off. The On/Off switch is located at the front of the treadmill.
To clean the treadmill belt and deck:
1. Make sure the treadmill is turned off.
Figure 2
2. Take a clean, dry cotton towel that is at least 36 in. (2 m) long and fold it
in half lengthwise.
3. Lift the running belt up and push the towel under the belt. Make sure a
few inches of towel extend over the deck trim on each side.
4. Push the towel forward to the front of the machine so it is located
beneath the safety stop key.
5. Turn the power switch to On .
6. Step onto machine by standing on the side rails and attach the stop key
lanyard to your clothes.
Important
DO NOT stand on the running belt at any time.
7. Stand firmly on both ends of the towel keeping your feet off of the treadmill running belt (Figure 2). Brace yourself using the
handlebars or side hand rails.
9