Model PD655 Large Display Process Meter
Instruction Manual
55
Programming Alarm and Preset Values (
SEtPtS
)
Alarm, preset, and preset offset values are programmed under the
SEtPtS
menu,
one at a time, starting with set point 1. The set points are programmed according
to whether they were assigned to process/rate or total during the
setup
program.
For set points assigned to process/rate it is necessary to program both a set and
reset point. For set points assigned to total, either a preset value or preset offset
value needs to be programmed.
The 4 discrete LEDs to the left of the display indicate which set point is being
programmed.
Figure 18.
Display Showing Location of Set Point LEDs
For set points assigned to process/rate, there are also two LEDs below the
display labeled
S
and
R
that indicate whether a set or reset point is being
programmed.
Figure 19.
Display Showing Location of Set, Reset, and Rate LEDs
When programming set points assigned to total, only one of the 4 discrete LEDs
below the display will be illuminated at a time. A flashing LED indicates that a
preset offset value is being programmed, a steady-on LED indicates that a preset
value is being programmed.
