Model PD650 Large Display Process Meter
Instruction Manual
55
Programming Alarm and Preset Values (
SEtPtS
)
Alarm, preset, and preset offset values are programmed under the
SEtPtS
menu,
one at a time, starting with set point 1. The set points are programmed according
to whether they were assigned to process/rate or total during the
setup
program.
For set points assigned to process/rate it is necessary to program both a set and
reset point. For set points assigned to total, either a preset value or preset offset
value needs to be programmed.
The 4 discrete LEDs to the left of the display indicate which set point is being
programmed.
Figure 17. Display Showing Location of Set Point LEDs
For set points assigned to process/rate, there are also two LEDs on the right side
of the display, labeled
S
and
R
, that indicate whether a set or reset point is being
programmed.
Figure 18. Display Showing Location of Set, Reset and Rate LEDs
When programming set points assigned to total, only one of the 4 discrete LEDs
on the left side of the display will be illuminated at a time. A flashing LED
indicates that a preset offset value is being programmed, a steady-on LED
indicates that a preset value is being programmed.
