■
6 Working with the application menu
48
6.10 Application «DIAGNOSTICS» *
* not available for firmware Nxx
See Chapter 4.5 “Activating the two main menus” and Chapter 4.6
“How the menu control operates” for the activation of the application
menu.
With the aid of the „DIAGNOSTICS” program you can verify the per-
formance of your balance. The internal weight is measured 10 times,
and the standard deviation is calculated from this and logged.
Operation:
Start the application (see Chapter 6.3 “Changing application / weigh-
ing mode”).
Display
Step
+0,0000
9
Press «
REF
»until „REPEATABILITY
TEST“ appears, than relase the key.
Repeatability test
- - 0000
The balance carries out a Zero mea-
surement (-- 0.000 g is shown
flashing).
measurement 1
EXIt
- - inT
The internal weight, if available, is
applied and measured (-- Int is
shown flashing).
measurement 1
EXIt
- - LLLL
In case no internal weight (SCS) is
available place a load onto the ba-
lance (-- LLLL is shown flashing).
measurement 1
EXIt
- - 0000
The balance carries out a Zero mea-
surement again.
measurement 2
EXIt
- - iNT / LLLL
The internal weight is applied and
measured again or place the same
external weight again.
measurement 1
EXIt
The balance repeates this measure-
ments for 10 cycles.