CUTTING ARM TRAVEL ADJUSTMENT
Refer to Figure 13
• Lower the blade as far as possible.
• Loosen the locknut.
• Turn the adjustment bolt out (counterclockwise) to
increase the cutting depth .
• Rotate the blade manually to check for contact. Avoid
touching blade points or edges.
• Repeat until adjusted properly, and tighten the locknut
to secure the adjustment bolt into position.
90° BLADE ALIGNMENT
Refer to Figure 14 and 15
• Rotate table to 0° position and lock in place.
• Lower the blade and engage the lock pin.
• Place a combination square on the table and press it
against the blade to check the blade squareness to
table.
• If the blade is not 90° square with the miter table, loosen
the bevel lock handle tilt the cutting head completely to
the left. Loosen the locknut on the bevel angle
adjustment bolt and use a 13 mm wrench to adjust the
bolt in or out to increase or decrease the bevel angle.
• Tilt the cutting arm to back to the right at 90° and
recheck for alignment.
• Repeat the adjustment if the blade is not at 90°.
• Tighten bevel lock handle and locknut when blade in at
90° alignment.
• When the blade is exactly 90° to the table, loosen the
bevel indicator screw and align the indicator to 0°
mark. Tighten screw.
45° BLADE ALIGNMENT
Refer to Figure 14 and 15
• Rotate table to 0° position and lock in place.
• Lower head assembly and lock in place.
• Loosen bevel lock handle and tilt the head assembly to
45° bevel. The indicator should be on the 45° mark. The
45° bevel stop should be in full contact with the 45°
bevel stop screw, and the blade should contact the full
length of the combination square.
• If the blade is not at 45° to the miter table, tilt the cutting
arm to the right. Loosen the locknut on the bevel angle
adjustment bolt and use a 13mm wrench to adjust the
bolt in or out to increase or decrease the bevel angle.
• Tilt the cutting arm to the left to 45°bevel and recheck
ofr alignment.
• Repeat steps 1 throught 4 if necessary.
• Tighten bevel lock handle and locknut when alignment
is achieved.
LASER ALIGNMENT
Refer to Figure 16
• Remove the locking screw on the battery cover using a
Phillips screwdriver and open the cover.
• Insert the two AAA batteries in the case.
• Put on the battery cover ,replace the locking screw and
tighten it securely.
6
OPERA
TION
Figure 14
Figure 15
Figure 13
Locknut
Adjustment bolt
Bevel lock handle
Combination square
Lock handle
0 mark
Locknut
Bolt
Indicator
Figure 12
Indicator
Miter scale
Miter handle
Positive stop
locking lever
