Cover plate
Arbor bolt
Blade collar
Blade
Blade
Arbor bolt
NOTE:
Pay attention to the pieces removed, noting their
position and direction they face. Wipe the blade collars
clean of any sawdust before installing the new blade.
INSTALLING BLADES
Refer to Figure 8
•
Fit blade between the chip deflectors and onto the inner
washer shoulder to install the 10” blade.
NOTE:
Make certain the rotation arrow on the blade
matches the clockwise rotation arrow on the lower guard.
•
Replace the outer washer in the proper orientation, and
tighten arbor bolt finger tight.
•
Press the arbor lock, holding it in firmly while turning
the blade counterclockwise. When arbor lock engages,
continue to press it in while tightening the arbor bolt
securely.
•
Rotate the cover plate back to its original position until
the slot in the cover palte engages with the cover plate
screw. While holding the lower blade guard, tighten the
screw with a Phillips screw.
CAUTIONS:
The lower blade guard must be raised to the
upright position to access the cover plate screw.
•
Lower the blade guard and verify that the operation of
the guard does not bind or stick.
•
Make sure the arbor lock is released so the blade turns
freely.
•
Do not use a blade larger or smaller than 10” and 5/8”
diameter arbor.
•
Never use the saw without the cover plate secure in
place. It keeps the arbor bolt from falling out and helps
to prevent the spinning blade from coming off the miter
saw.
•
After installation of new blade, lower the blade into the
table slot and check for any contact with the base or turn
table structure. If blade contacts table, seek authorized
service. .
FENCE SQUARENESS ADJUSTMENT
Refer to Figure 11
•
Loosen the three fence locking bolts.
•
Lower the cutting arm and lock in position.
•
Place a square. Lay the heel of the square against the
blade, and the ruler against the fence as shown. Check
to see if the fence is 90° to the blade.
•
Tighten the fence locking bolts after adjustment.
•
After fence has been aligned, use a scrap piece of wood
to make a cut at 90° then check squarerness on the
piece. Readjust if necessary.
MITER SCALE
Refer to Figure 12
The miter scale assists the user in setting the desired
miter angles from 45° left to 45° right.The miter saw table
has nine of the most common angle settings with positive
stops at 0°, 15°, 22.5°, 31.6° and 45°. Theses positive
stops position the blade at the desired angle quickly and
accurately.
• Turn the miter handle counterclockwise to unlock the
miter table.
• Press down the positive stop locking lever when holding
the miter handle.
• Rotate the table to the desired angle.
• Release positive stop locking lever.
• Tighten miter handle.
5
ASSEMBL
Y
Figure 11
WARNING
Figure 9
Arbor lock
Figure 10
Fence
locking bolt
Fence
Fence
locking bolt
