SYMPTON
POSSIBLE CAUSE(S)
1. Pivot bolt too tight
2. Pivot spring not replaced properly
after service
3. Sawdust build-up
SOLUTIONS
1. Loosen pivot bolt lock nut
2. Contact Service center
3. Clean and lubricate moving parts
Blade binds jams ,burns
wood
1. Improper operation
2. Dull or wareped blade
3. Improper blade size
4. Wood is moving during cut
1. See OPERATION section for the proper use.
2. Replace or sharpen blade
3. Replace with 10-in.diameter blade
4. Use hold down clamp to secure workpiece
to table
The laser guide fails to turn
on
1. The batteries are dead
2. The battery contacts need
adjustment
1. Replace with new AAA batteries
2. Reload the batteries and make certain that
they make solid contact to the battery spring
Cutting arm will not fully raise
or blade guard won’t fully
close
Saw vibrates or shakes
1. Saw blade not round/damaged/
loose
2. Arbor bolt loose
1. Replace blade
2. Tighten arbor bolt
TROUBLESHOOTING
14
