Powerhorse M1175B, Owner'S Manual

Page: 43 / 94

43
Assembly Instructions
Step 5 – Tank Weldment

Screw finger-tight (1) Return Line Filter Head onto hydraulic tank
return port.
NOTE: the arrow on filter head should point towards the
tank.

Wrench-tighten the fitting to 1.5-3.0 turns past “finger tight” position.
Consider final orientation position as to not exceed the recommended
TPFT. Properly assembled fittings total thread engagement should be
3.5-6 turns.

CAUTION: Never back off an installed pipe fitting to achieve proper
alignment. Loosening installed pipe fittings will corrupt the seal and
contribute to leakage and failure.

Screw finger-tight (1) Return Line Filter Canister onto bottom of
return line filter head until gasket makes contact. Tighten filter an
additional 1/2 turn.
Tools Needed

Pipe Wrench
OR

Crescent Wrench
Return Line
Filter Canister
Qty: 1
Return Line
Filter Head
Return Line
Filter Canister
Hydraulic Tank
Return Port
Parts Needed from Manual Bag:
Return Line
Filter Head
Qty: 1