the vacuum motor will turn off). Drive the machine to a service area for daily maintenance and
review items that may need service.
Empty the solution tank, by opening the
solution hose valve
into a drain. Rinse the tank with
clean water to prevent any build-up of dried up chemicals that could cause clogging in the
plumbing.
Empty the recovery tank as described on line
11
and
12
.
Remove the
brushes
or pad holders and rinse them in warm water and hang to dry.
Remove the
rear
squeegee
, rinse with warm water and reinstall after cleaning.
Check the
maintenance schedule
on the next page and perform any required maintenance
before storing the machine.
Store the machine indoors in a clean dry place. Keep from freezing. Leave solution and
recovery tank lids open for ventilation to prevent odor build-up.
Turn
Key switch
OFF
(O)
and remove key.
MAINTENANCE SCHEDULE
Daily Weekly
Monthly
Yearly
Charge Batteries
Check Each Battery
Cell(s) Water Level
Lubrication –
Grease Fittings,
chains, etc.
Check Carbon
Brushes
Check/Clean Tanks
& Hoses
Inspect Scrub
Housing Skirts
Check/Clean/Rotate
the Brushes/Pads
Inspect and Clean
Solution Filter
Check/Clean the
Squeegee
Clean Spray jets on
Cylindrical System
Check/Clean
Vacuum Shut-Off
Float
Check/Clean the
Vacuum Motor
Foam Filter
Clean Hopper on
Cylindrical System
Check the vacuum motor carbon motor brushes once a year or after 300 operating hours. The
brush motor carbon brushes should be checked every 500 hours or once a year.
NOTE:
Refer to the Service Manual for more detail on maintenance and service repairs.
LUBRICATING THE MACHINE
Regularly scheduled lubrication of certain machine parts should be performed to insure
trouble-free operation of the machine.
Apply a generous amount of grease into the fittings on
the machine until grease seeps out around the bearings.
The grease points are listed below:
Rear squeegee caster wheel axle (2)
Rear squeegee caster wheel stem (2)
Apply lubricant or light machine oil to lubricate the:
Rear squeegee general pivot points
Scrub deck linkages
Drive wheel assembly seals.
18
