OFF-AISLE WAND (optional)
The
Phoenix
is equipped with a ready-to-use built-in telescoping off-aisle wand system for use
in hard to reach areas. This integrated system eliminates attaching hose for use and detaching
hoses for storage. By turning the
pump switch
ON (located behind the right handle of the
control console) the off-aisle wand is ready to use in seconds. After use, simply flip the switch
OFF and return the wand to it’s original storage location. The wand is also equipped with the
patented flip-flop tool that allows the operator to switch from scrub brush to squeegee tool by
just rotating the tool end.
OFF-AISLE WAND TOOL
The off-aisle wand tool as described in the previous page is composed of the following items:
The
recovery hose
is connected to the end of the wand on one end and to the recovery tank
hose on the other end. This hose has swivel cuffs on both ends that allow the operator a good
range of motion and the solution hose to be inside the recovery hose.
The
trigger
controls the solution flow to the spray jet. Squeezing the trigger opens an internal
valve to dispense cleaning solution.
The coiled
solution hose
acts as a conduit from the trigger to the spray jet, and allows hose to
be extended along with the wand.
The
spray jet
dispenses the cleaning solution to soak soiled areas that are not accessible to
the main scrub deck.
The
telescoping wand
allows the length to be adjusted for operator comfort and better
storage when not in use.
Sliding the
wand extender
forward (as shown above) extends the wand length during use and
retracts the wand by pulling it back for the storage position.
The flip-flop tool gives the operator complete flexibility when changing from the
scrub brush
mode to
vacuum squeegee
mode by simply rotating the end.
When the off-aisle wand switch is turned ON, six LEDs on the battery gauge will flash to
indicate that you are in the off-aisle tool mode. This switch turns on the pump to supply
solution to the wand spray jet and the vacuum motor to recovery the dirty water.
15
