Power SUA2700iD, Owner'S Manual, Page: 19 / 124

Page 17
7. Allow generator to run at no load for few minutes
upon each initial start-up to permit engine and
generator to stablize.
Select the Fuel Source (Propane/LPG)
2. Turn the fuel source switch to the propane/LPG
position.
5. Push the choke knob in to the “RUN” position.
3. Turn the engine switch to the “ON”(l) position.
4. The Propane/LPG priming button is located on the
propane hose. Press the button for 3 - 5 times to
prime the engine.
6. Pull recoil starter slowly until resistance is felt,
then pull rapidly.
NOTE:
Keep choke knob in “ START ” position for only 1 pull
of the recoil starter. After first pull, move choke knob
to the “
RUN ” position for up to the next 3 pulls of the
recoil starter. Too much choke leads to spark plug
fouling/engine flooding due to the lack of incoming
air. This will cause the engine not to start.
If engine starts after 3 pulls but fails to run. Or if unit
shuts down during operation, make sure unit is on a
level surface and check for proper oil level in
crankcase. This unit may be equipped with a low oil
protection device. If so, oil must be at proper level
for engine to start.
When starting engine, pull cord slowly until
resistance is felt and then pull rapidly to avoid
kickback.
Starter cord kickback (rapid retraction)
will pull hand and arm toward engine
faster than you can let go which could
cause broken bones, fractures, bruises,
or sprains resulting in serious injury.
WARNING
1. Fully open the Propane/LPG cylinder knob.
NOTE:
If the engine fails to start in 1-2 pulls with choke in
the
“RUN” position, then repeat the STEP 4 and
STEP 6.