Power Stroke PS906811P Series, Operator'S Manual

Page: 21 / 48

Page 17 — English
REPLACING FUEL FILTER
See Figure 20.
Occasionally the fuel filter may become clogged and need
replacing. To purchase a replacement fuel filter contact
Powerstroke customer service at 1-877-617-3501.
NOTE: Fuel tank must be empty before replacing fuel filter.
Run unit until tank is empty, if needed, or inspect filter prior
to fill-up.
To replace:

Turn the fuel valve to the OFF position.
  Remove the fuel line from both sides of the filter by
squeezing the ends of the retaining clip with pliers.


Slide the fuel line off.
  Replace with new fuel filter.


Reinstall fuel lines to new fuel filter.
 Turn the fuel valve to the
ON
position.
CHANGING ENGINE BATTERY CHARGE
CIRCUIT FUSE
See Figure 21.
NOTICE:
Do not use a higher rated fuse other than the specified
amperage. This could cause damage to the product.

Grip both sides of the plastic fuse holder and twist apart
to reveal the fuse and spring.
 Insert new fuse and refasten the fuse holder by pushing
the two sides of the connector together and twisting to
secure.
NOTE: If spring came out of fuse holder when it was
opened, it should also be replaced inside the fuse holder
before securing.
USING THE BATTERY MAINTAINER
See Figure 22.
When storing the generator, the battery maintainer can be
connected to keep the battery fully charged and ready for use.
NOTE:
The battery maintainer provided should only be used
with the 12V 9Ah/20HR lead acid battery model RT1290H
supplied with this generator.

Connect the battery maintainer to the power supply. Make
sure the power supply is normal household voltage, 120
volts, AC only, 60 Hz.

Attach the other end of the battery maintainer to the
charging cable attached to the battery. The red light on
the plug will illuminate to show the battery is charging.
The battery will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
When battery is fully charged, the red light will turn green.
NOTE: If the light does not illuminate, the fuse on the
charging cable may need to be replaced. Check the fuse
and replace if needed.

Disconnect the battery maintainer before operating the
generator. Place the cover on the charging cable when
not in use.
BATTERY REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please recycle
or dispose of batteries properly.
This product uses lead acid batteries. Local,
state or federal laws may prohibit disposal of
batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
WARNING:
Upon removal, cover the battery’s terminals with heavy-duty
adhesive tape. Do not attempt to destroy or disassemble
battery or remove any of its components. Lead acid batter-
ies must be recycled or disposed of properly. Also, never
touch both terminals with metal objects and/or body parts
as short circuit may result. Keep away from children. Failure
to comply with these warnings could result in fire and/or
serious injury.
MAINTENANCE