Power Electronics SD750FR, Hardware And Installation Manual

Page: 13 / 80

POWER ELECTRONICS SD750FR
SAFETY INSTRUCTIONS
11
NOTICE
RECEPTION
SD750FR drives are delivered tested and perfectly packed.
In the event of damage during transport, please ensure to notify the transport agency and POWER
ELECTRONICS: 902 40 20 70 (Interna34 96 136 65 57) or your nearest agent, within 24h from
receiving the goods.
UNPACKING
Make sure model and serial number of the variable speed drive are the same on the box, delivery note
and unit.
Each variable speed drive is delivered with Hardware and Software technical manuals.
RECYCLING
Packaging equipment must be recycled. Separate all different materials (plastic, paper, cardboard,
wood…) and place them in the corresponding containers. Ensure waste collection is properly managed
with a Non-Hazardous Waste Agent.
To guarantee health and natural environmental sources protection, the European Union has
adopted the WEEE directive concerning discarded electric and electronic equipment
(SEEA).
Waste of electrical and electronic equipment (WEEE) must be collected selectively for
proper environmental management.
Our products contain electronic cards, capacitors and other electronic devices that should
be separated when they are no longer functional. These WEEEs should be managed
accordingly with a Hazardous Waste Agent.
Power Electronics promotes good environmental practices and recommends that all its
products sold outside of the European Union, once they reach the end of their life, are
separated and the WEEE managed according to the particular country applicable legislation
(especially: electronic cards, capacitors, and other electronic devices).
If you have any questions about the electric and electronic equipment waste, please contact Power
Electronics.
ELECTROMAGNETIC COMPATIBILITY (EMC)
The drive is intended to be used in industrial environment (Second Environment). It achieves compliance
with category C3 defined in IEC/EN 61800-3 standard when the installation recommendations within this
manual are followed. The driver can optionally operate in domestic environments (First Environment),
complying with category C2 defined in IEC / EN 61800-3 standard. For category C1 consult Power
Electronics. Optional IT filter.
Select communication and control system according to the drive EMC environment. Otherwise, systems
could suffer from interferences due to a low EMS level.
CAPACITORS DEPLETION
If the drive has not been operated for a long time, capacitors lose their charging characteristics and are
depleted. To prevent depletion, once a year run the device under no-load conditions during 30-60 minutes.