NB Wall
POWER ELECTRONICS
26
PREPARATION FOR INSTALLING THE EQUIPMENT
•
Then, fix the bracket to the wall, with the flap where the holes are located at the bottom and in contact
with the wall, and the grip flap being at the top separated from the wall. Check that it is correctly
leveled.
•
Then hang the charger by inserting the grip flap into the corresponding opening on the back of the
charger.
•
Finally, secure the rear of the charger to the wall with two screws through the corresponding holes.
The following images show the location and diameter of the anchor holes. Also, a cut of the equipment´s
base is presented (section S-S). The values are indicated in millimeters
Frame 1:
GENERAL DIMENSIONS FRAME 1 [mm]
A
B
C
D
E
F
G
R1
Ø2
70
170
110
130
58,4
22
200
42
8
Summary of Contents for NB WALL ADVANCED
