![background image](http://html.mh-extra.com/html/power-craft/48205/48205_instruction-manual_1586376028.webp)
28
You can lock the saw arm in the low position
by pushing the lock pin in until it engages.
The saw must not be used if the lock pin is
securing the saw arm in a fi xed position.
The mitre saw may only be lifted by the
carrying handle (17) during transport. The
saw arm must be locked during transport.
Preparation
Attach the mitre saw securely to a work
bench or workstation by fastening it securely
using bolts and nuts through the mounting
holes in the base (13) of the saw.
Push the support rails (10) into the holes (a)
on each side of the mitre saw and secure
them in the required position using the wing
nuts.
Insert the screw clamp’s (14) stanchion into
one of the sockets on the saw and secure it
using the wing nut. Tighten the clamp at the
required height using the wing nut on the
side of the clamp and secure the workpiece
by tightening the knob.
Note that in some cases the clamp may block
the saw arm movement. If this happens, use
a diff erent clamp to secure the workpiece.
Fit a dust bag or connect a vacuum cleaner or
dust extraction device to the dust extraction
connector (6) on the mitre saw.
The saw is now ready for use.
Settings
Setting the bevel angle
Loosen the lock knob (15) for the bevel angle
and tilt the saw arm to the left, until the
indicator is level with the required setting on
the scale for the bevel angle. Retighten the
lock knob.
Setting the mitre angle
Loosen the lock knob (11) for the mitre angle.
Turn the saw bench to the right or left, until
the indicator is level with the required setting
on the scale for the mitre angle. Retighten
the lock knob.
A