![background image](http://html.mh-extra.com/html/power-craft/48205/48205_instruction-manual_1586376029.webp)
29
GB
Setting the saw depth
The saw arm must be locked and in the top
position.
Adjust the depth adjustment screw (7)
towards the stop plate. Make sure that the
saw depth is not set so that the saw blade
comes into contact with the base of the saw.
Sawing
Check that the mitre saw is correctly set up
and that all knobs and screws are correctly
tightened before starting to saw.
Lift the clamp (14) high enough so that the
workpiece can be pushed between it and the
saw bench. Position the workpiece touching
the saw bench and rest (9) so that it is stable.
Then secure the workpiece using the handle
on the clamp.
Make sure that long items are supported.
Never hold the item in place by hand.
Press and hold the release button (2) for the
blade guard. Press the on/off button (1) to
start the mitre saw.
The work light up the work area and emits a
visible beam that marks the saw line.
Allow the mitre saw to achieve full speed
before applying it to the workpiece.
The blade guard will open automatically
when the blade comes into contact with the
item.
Do not try to force the saw to either side.
Release the on/off button immediately if the
blade jams in the workpiece.
Release the on/off button once sawing is
complete. Only lift the saw arm once the
blade has fully stopped.
Check that the blade guard closes when the
saw is lifted off the item.
Sawing with the telescopic extension
Loosen the lock knob for the telescopic
extension (16).
Pull the saw arm out towards you as far as
possible. Start the saw as described, and cut
the workpiece from the outside in. Release
the on/off button once sawing is complete.
Only lift the saw arm once the blade has fully
stopped.
Replacing the saw blade
Disconnect the saw from the mains.
Press the release button (2) for the blade
guard and push the blade guard (4) fully to
the side.
Press the spindle lock (B) by the handle, turn
the saw blade until it locks.
Hold the spindle lock (B) in and loosen the
lock screw (5) for the blade by turning it
clockwise using the spanner provided.
Remove the lock screw and outer fl ange and
carefully lift the saw blade off the spindle.
Lift off the inner fl ange.
Do not dispose of the old blade in your
domestic refuse. Dispose of it correctly in
accordance with local guidelines.
Clean any fi lings and sawdust from the
spindle and fl anges. Lubricate the spindle,
fl anges and lock screw with a few drops of oil
or a spray lubricant.
B