![background image](http://html1.mh-extra.com/html/pottinger/eurohit-58-n/eurohit-58-n_operating-instructions-manual_1583515013.webp)
GB
USE
- 13 -
9600-GB EINSATZ (212)
Clearing field edges (border tedding) to the left or to the right
Clearing field edges can be carried out by swinging the runner wheel.
1.) Swinging the runner wheel hydraulically on machines
with central adjusting equipment
- Open stopcock (position E with two-way stopcock).
Position E1 when using a three-way stopcock (see also chapter
"HITCHING").
- Operate servo-valve on the tractor.
To swing the runner wheel left move servo-valve to "lift"
position. To swing runner wheel right move servo-valve to
"lower" position.
2.) Swinging the runner wheel mechanically on
machines with central adjusting equipment
- Release locking bolts by pulling the rope (S).
- Turn the tractor wheels in the direction of the field edge and
drive forward at the same time. The machine's runner
wheels swing in the opposite direction.
- Let go of the rope (S) and make sure that the locking bolts
are correctly engaged.
Note
The slanting axles make border tedding possible with the three point machines. In this working
position the swivel area (9) is used to its full extent.
When driving around bends away from the edge of the field or at the end of the field, the machine
must therefore be lifted.
Attention
!
The machine swings back into the central position (M).
TD12/93/9
S
TD12/93/8
A
E1
E2
A
E
TD31/90/21