Maintenance and servicing
In order to keep the machine in good condition even after a longer
period of operation, please observe the following notes:
- After the first hours of operation, tighten all screws.
In particular the tine connections (12 kpm), the tine bar
connections (9 kpm) and the slewing headstock connections
should be checked.
- Always keep the stipulated air pressure in the tyres.
- Grease the lubrication points in accordance with the regulation
(see lubrication schedule).
Grease the lubrication nipples with universal grease after
every 20 hours of operation.
- Before leaving the machine over winter, oil all the joints well
and grease all bearings.
Intake transmission
The intake transmission runs in oil which must
be renewed or added to after every year of
operation:
- Pour gear lubricant oil into the
intake transmission (see
enclosure on fuel regulation).
Changing tines
- Remove broken tine after loosening the hexagonal nut and fit
new tine.
- For correct fitting observe the direction of the rotors!
- Tighten hexagonal screw with 12 daNm (= 12 kpm).
- Fit the safety shackle correctly (longer side (6) outside)!
- Bj. 2001:
Using the tine gauge check the correct position of the
tine.
Gas container
Beware!
No welding, soldering or mechanical works of any kind
may be carried out on the container.
Note
• According to
m a n u f a c t u r e r ' s
information all gas
containers have a slight
pressure drop after a
certain amount of time.
• The gas loss (nitrogen)
amounts to 2-3 % per
year.
• After 4-5 years it is
recommended that
container pressure be
checked and if necessary
corrected.
Alteration of gas container pressure
This work may only be carried
out by customer service or a
specialist.
In order to reduce or increase
the pressure in the gas
container a special filling and
checking device is necessary.
Pressure in the gas container: 80 bar Nitrogen (N).
TD12/93/10
Stickstoff
(N)
TD 7/95/3
Drehrichtung
direction of rotation
12 kpm
+ Bj. 2002
- Bj. 2001
MAINTENANCE
GB
- 15 -
0200-GB Wartung_209
