Hitching of machines with three point
linkage
Safety hints:
see supplement-A1 points 7.), 8a. - 8h.)
1. Pinning the machine to the three point linkage.
2. Fix the hydraulic lower link (4) in such a way that the
machine cannot swing out sideways.
3. Push in the support foot (5) and secure.
-
Before using for the first time, the length of the drive shaft
must be checked and adjusted if
necessary (see also supplement
B "Drive shaft adaption").
Locking the headstock during use on
roads and when lowering
For transport the
headstock (SB) must be
locked using a lock nut.
A = working position
B = transport position
Important!
Only reposition the lock
pin when the machine
is in the raised position.
Release rope
-
Run rope (S) into tractor
cabin.
Connecting hydraulic system to the tractor
For reasons of accident prevention the p.t.o. must be
switched off and the rotors must come to a stand still
before raising the side rotors.
-
Only connect hydraulic system to the tractor when stopcock
is closed (position A).
Note
• Hydraulic line L1 is available in every model.
• For machines with hydraulic wheel adjusting equipment it is
necessary to have a second simple functioning hydraulic
connection on the tractor. The two-way stopcock (H2) is
connected to this.
• If the tractor only has one hydraulic connection, then instead
of a two-way stopcock (H2), a three-way stopcock (order no.
445.059) and the plug (order no. 448.051) which goes with
it can be fitted.
This means any individual hydraulic circuit can be selected.
With this connection variation, the backflow choke
valve (D) may not be removed.
Position A:
Stopcock closed.
Position E1:
Swivelling of outer
rotors.
Position E2:
Swivelling of wheels.
TD12/93/15
L1
H2
A
E
D
TD12/93/13
A
E1
E2
TD12/93/14
445.059
448.051
L1
D
L1
TD34/90/4
5
4
HITCHING
GB
212 / ANBAU 9500-GB
- 5 -
