PostProcess Technologies, Inc. • www.postprocess.com • REV A | page 19
The DECI is designed to detect conditions at the start of an Auto Run cycle that may inhibit the performance of
the machine. These conditions are not yet at a critical stage but are presented to alert the operator to take action
in order to achieve maximum machine efficiency.
The warning can be ignored and the cycle started by pressing the
CONTINUE
button (Figure 16. Auto Run
Warning Screen).
To take corrective action based on the warning that is presented, the operator can choose to drain the tank and
refill. To correct pH warnings, the operator can run a dosing cycle to raise the pH or add water to lower the pH.
For more information about Drain and Dose cycles refer to
Section 1.4 Manual Operations
. Once action is taken,
press the
CONTINUE
button to proceed.
After the Auto Run cycle has completed, the DECI will display a confirmation that the Automatic Run Has
Completed. Press the
CHECK
button to return to the
Auto Run
screen.
The control buttons for the cycle are shown left. As indicated, the
PLAY
button is gray because the cycle is running. The two available control
buttons are
PAUSE
and
STOP
. To pause or stop the cycle for any reason,
press the corresponding button. Whenever the
PAUSE
or
STOP
button is
active, it will be gray, and the
PLAY
button will turn blue to show that it is
available.
Figure 16.
Auto Run Warning
Screen
1. Operation
If there is a question mark displayed next to the
PLAY
button (shown below), it is an indication that there is a
condition that is inhibiting the cycle from starting. For more information, press the question mark and a
message screen will display.
NOTE
