POSline ITT4300, Manual

Page: 5 / 46

POSline ITT4300 Label Printer
5
Power Supply
Setting up the Printer
Before setting up the printer you should first consider the following:
•
Find a solid flat surface with adequate room for the printer. Make
sure there is enough room on the top side for the media and
ribbon access.
•
The location should be near the host or terminal. Consider the
distance between host and printer for the communication cable
(serial or parallel cable)
•
Clear the ground and isolate from other electrical cables for the
power adapter.
•
Connecting the Power Cord
Note: For ITT4300, make sure the power switch on rear panel been
switched to correct position and fit local power source.
•
Leave the power switch at the ”O” position.
•
Connect the power supply plug to the power jack and the other
end to your AC source.