Installing Power Adapter to Gen 8E Base Stand
Power adapter is used to provide power which your terminal needs to be
operated normally. Please go through the below steps to install the power
adapter into Gen 8E base stand. If the power adapter is already installed
to Gen 8E base stand, you may skip this section
1.
Lay your POS terminal on a flat surface
with its bottom facing towards you.
2.
Take the AC power adapter with its
rubber feet facing you. Place the bottom
side of the power adapter into the
bottom of the power adapter
compartment first, and then push it
down into place.
3.
Place two brackets separately on the top
and bottom sides of the power adapter
compartment as shown in the figure.
Then, fasten two brackets with four
fixing screws.
4.
Before threading the cable through the cable exit, loosen two fixing
screws for the bracket of the middle compartment. Then, slide the
bracket in the direction shown by the arrow to remove the bracket for
the middle compartment.
Bracket
16
