Troubleshooting
ROBO-8112VG2AR User’s Manual
5-1
Chapter 5
Troubleshooting
This chapter provides a few useful tips to quickly get ROBO-8112VG2AR running with
success. As basic hardware installation has been addressed in Chapter 2, this chapter
will focus on system integration issues, in terms of BIOS setting, and OS diagnostics.
5.1
Hardware Quick Installation
ATX Power Setting
Unlike other Single board computer, ROBO-8112VG2AR supports ATX only.
Therefore, there is no other setting that really needs to be set up. However, there are
only two connectors that must be connected—J19 (4 pins CPU+12V main power
connector) & 24 pins ATX Power Connector.
Serial ATA Hard Disk Setting for IDE/RAID/AHCI
Unlike IDE bus, each Serial ATA channel can only connect to one SATA hard disk at a
time; there are total six connectors, SATA1~6 port. The installation of Serial ATA is
simpler and easier than IDE, because SATA hard disk doesn’t require setting up
Master and Slave, which can reduce mistake of hardware installation. All you need to
operate IDE, RAID (0/1/5/10) and AHCI application for system, please follow up
setting guide in BIOS setup utility
