.(/0(()
#*
Windows-NT 4.0 users.
1. Please install your network adapter manually in Control Panel -> Network ->
Adapter. Drivers are required at this stage.
2. Proceed “Binding” after you load in the driver.
3. Change to Protocol label and load in the protocols that you are interested
(generally, TCP/IP). Configuring IP, gateway and DNS is
required for TCP/IP
protocol.
4. Proceed again “Binding” after you complete the protocol loading.
5. Restart your system.
6. There is also situation that the installed network adapter is not working anymore
for you, or old network driver stays in the system after you change your network
card. Please remove all the network adapters and protocols from network setup
menu and redo the loading of driver and protocols again.
7. Network setup within Windows-NT 4.0 is not as easy as within Windows 98/ME.
8. Special familiarity and care are required for a successful installation.
(
2 0
Q: OK. I have finished up hardware installation, but I got nothing when I power
on the system. Why?
A: Please double check if every connector is attached with the correct cable.
Q: I power on the system, but the CPU speed is not correct. Why?
A: This applies to Engineering Sample processor ONLY. If you have ever loaded
the BIOS optimal default, thank you for doing so. However, this will force the
BIOS to pick up the default CPU core/bus ratio as well. It needs to be
emphasized again that ROBO-7710VLA does not have switch or jumper to
configure CPU core/bus ratio. This is done through BIOS automatically. Please
check in the “Frequency/Voltage Control” section of Chapter 4 to adjust this
core/bus ratio (only available when you plug in the engineering sample
processor from Intel). System default setting is automatically setting when you
plug in commercial processors from Intel and you will not see the CPU Clock
Ratio item in the BIOS setting screen.
Q: I connect two IDE devices over one IDE flat cable, but the system either does
not start, or just hangs from time to time. Why ?
A: Make sure that you have configured the two IDE devices as a master and a slave,
respectively.
Summary of Contents for PEB-7710VLA
Page 10: ......
Page 32: ...in eax dx...
