Portwell PEB-7710VLA, User Manual

Page: 27 / 70

,-,((
!
&&
PEB-7710VLA provides two DDR-SDRAM DIMM slots to support 2.5V DDR-
SDRAM as on-board main memory. The maximum memory size can be up to 2GB.
Auto detecting memory clock according to BIOS CMOS settings.
Watch out the contact and lock integrity of memory module with socket, it will
impact on the system reliability. Follow normal procedures to install your DRAM
module into memory socket. Before locking, make sure that all modules have been
fully inserted into the card slots.
Note:
To maintain system stability, don’t change any of DRAM parameters in BIOS setup
to upgrade your system performance without acquiring technical information.
""'
To install your PEB-7710VLA into standard chassis or proprietary environment, you
need to perform the following:
Step 1: Check all jumpers setting on proper position
Step 2: Install and configure CPU and memory module on right position
Step 3: Place PEB-7710VLA into the dedicated position in your system
Step 4: Attach cables to existing peripheral devices and secure it
Step 5: Attach 4-pin 12V power cable of ATX power supply to on board 12V CPU
supplementary connector (J5)
WARNING
Please ensure that your PEB-7710VLA is properly inserted and fixed by mechanism.
Otherwise, the system might be unstable or do not work due to bad contact of
golden finger and ISA-bus slot.
Note:
Please refer to section 3-4-1 to 3-4-3 to install INF/VGA/LAN drivers.