Portwell FUDA3-S1 12 Series, User Manual

Page: 85 / 104

BIOS Setup Information
FUDA3-S1x12 Series Panel PC User’s Manual 4-26
Parity
A parity bit can be sent with the data bits to detect some transmission errors.
Even: parity bit is 0 if the num of 1’s in the data bits is even.
Odd: parity bit is 0 if num of 1’s in the data bits is odd. Mark: parity bit is always
1. Space parity bit is always 0. Mark and Space Parity do not allow for error
detection. They can be used as an additional data bit.
Choices: None (
★ Default), Even, Odd, Mark, Space
Stop Bits
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow devices
may require more than 1 stop bit.
Choices: 1 (
★
Default), 2
Flow Control
Flow control can prevent data loss from buffer overflow. When sending data, if
the receiving buffers are full, a ‘stop’ signal can be sent to stop the data flow. Once
the buffers are empty, a ‘start’ signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop signal.
Choices: None (
★
Default), Hardware RTS/CTS
VT-UTFB Combo Key Support
Enable VT-UTFB Combination Key Support for ANSI/VT100 terminal
Choices: Enabled (
★
Default), Disabled.
Recorder Mode
With this mode Enabled only text will be sent. This is to capture terminal date
Choices: Disabled (
★ Default), Enabled.
Resolution 100x31
Enabled or Disabled extended terminal resolution
Choices: Disabled (
★ Default), Enabled.
Putty KeyPad
Select Function Key and KeyPad on Putty
Choices: VT100 (
★
Default), LINUX, XTERMR6, SCO, ESCN, VT400