BIOS Setup Information
PEB-4700 User’s Manual
4-16
KB Power ON Password
You can set the password to limit operating KB Power On system by pressing enter.
Hot Key Power ON:
Options
You can use this item to select operating Hot Key to Power On system.
The choice: Ctrl+F1 ~ Ctrl+F12.
Onboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has no
floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with which
I/O address.
The choice: 3BC/IRQ7, 378/IRQ7, 278/IRQ5 and Disabled.
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select Normal,
Compatible, or SPP unless you are certain your hardware and software both support
one of the other available modes.
The choice: SPP, EPP, ECP and ECP+EPP, Normal.
EPP Mode Select
This item allows you to determine the IR transfer mode of onboard I/O chip.
The choice: EPP1.7, EPP1.9.
ECP Mode Use DMA
This item allows you to select a DMA channel for the parallel port for use during ECP
mode.
The choice: 3, 1.
PWRON After PWR-Fail
This item allows you to select if you want to power on the system after power failure.
The choice: Off, Former-Sts
