INSTALLATION
GUIDE
PULL ARM
INSTALLATION
Install the slide track assembly at the pull side of the door at the proper location from the hinge end of the door as shown below:
Offset (double egress) Pull Arm
For reveal greater than 0 degrees
Use 20mm Spindle
Standard Pull Arm
For 0-degree reveal
Use 20mm spindle
Slide Track
To install the pull arm, and allow proper preload the operator must be powered to the fully open position.
Power the door to the open position through the use of the hold-open switch on the side of the header. It may be necessary to first
execute a “setup” on the operator prior to doing this. Refer to the applicable section within this User’s Guide for proper instruction.
Once the operator is rotated to the fully open position, manually move the door to the desired fully open position and insert the slide
track guide block into the track. When completed, the end caps to the track can be installed.
WWW.PORTALP.COM
|
21
Automatic Doors & Building Access Control
SW10
(Full Power) & S
W19
(Low Energy)
