Porkka FESTIVO MED XW70L, Additional Manual

Page: 62 / 88

ENGLISH
62
MED XW70L
Alarms
Note!
Reset the alarm signal by pressing any button. The alarm code stays on the display.
HA High temperature alarm
The temperature inside the cabinet has exceeded the set alarm temperature. The alarm can be
instigated by sudden icing of the evaporator. Initiate additional manual defrost. See instructions on
the previous page. Ensure the cabinet has not been loaded with warm products. Check that a door
has not been left open. Check that any product is not blocking air circulation within the cabinet. The
cabinet is meant to keep ready chilled products cold.
LA Low temperature alarm
The temperature inside the cabinet has fallen below the set value. Ensure that the products put into
the cabinet are not too cold.
The temperature alarm will reset automatically after the interior of the cabinet returns to the set
temperature range. If this does not happen, move the products to another cabinet and contact your
service provider.
dA Door open alarm
Close the door carefully and the alarm will reset automatically.
HA2 Condenser alarm (MEDLAB 400 series and freezers only)
MEDLAB 400 cabinet alarms of dirty condenser / condenser filter. Check that ambient temperature
is not more than +32°C and clean condenser / filter. If alarm recurs call to service.
P1 Cooling control probe failure *
P2 Defrost control probe failure *
P4 Condensing temperature probe failure (MEDLAB 400 series and freezers only)*
*Note! The cabinet operates on its standby system and will hold normal temperature, but reset the
alarm signal and immediately contact your service provider.
EE Data failure
To reset an ‘EE’ Alarm on the display and resume normal function of the equipment press
any key for 3 seconds. After this ‘rSt’ message will be displayed again for 3 seconds and the
equipment should return to normal function.