WAT E R G A R D E N I N G T O T H E M A X
TROUBLESHOOTING
REPLACEMENT PARTS: UVC9/18/24/36/60W
Problem
Reason
Solution
The device is not getting power.
• Check the electrical socket/GFCI.
• Check the power supply.
The plug is disconnected from the
electrical socket.
Connect the plug to the electrical socket.
Protective device pivot might have been
damaged during maintenance operations.
Replace the device.
The UV-C lamp is improperly installed
into the light fixture.
See Assembling section, clause 6
Defective UV-C lamp.
Replace the UV-C lamp.
Filter overheating.
Disconnect the plug from the electrical socket
and wait minimum 30 minutes, then connect
the device to the power supply again.
Size of the filter used may be inappropriate
for the filtering requirements of the pond.
Contact a qualified installation technician.
Clean the tube following instructions in
the QUARTZ TUBE CLEANING section.
Worn-out UV-C lamp.
Replace the UV-C lamp following
instructions in the ASSEMBLING section.
PMAX UVC Water Clarifier Instructions.indd 7
March 2021
NO.
The quartz tube is dirty.
UV-C lamp
does not come on
Cloudy water
(NOTE: THESE ARE THE MOST USED)
QUARTZ TUBE
O-RING FOR QUARTZ TUBE
1" HOSETAIL FITTINGS (UVC9W)
Ø 1”, 3/4”, 1/2” (25mm, 20mm, 13 mm)
1-1/2" HOSETAIL FITTINGS (UVC24W/UVC36W/UVC60W)
Ø 1-1/2”, 1-1/4”, 1” (38mm, 32mm, 25mm)
O-RING FOR BALLAST ASSEMBLY
CLOSURE CAP FOR OPTIONAL OUTLET (UVC24W/UVC36W/UVC60W)
UV-C LAMP
DESCRIPTION
1" HOSETAIL FITTINGS (UVC18W)
Ø 1-1/2”, 1-1/4”, 1” (38mm, 32mm, 25mm)
2
3
4
10
13
12
Page 8
P O N D M A X . C O M
Page 10
