11
10. After all Sensitivity-Level finish adjustment, press “SELECT”, will show “AP”,
means entered Application Mode adjustment option. Press “ENTER” will show
“AP-1”, means “Application 1”, press “SETUP”can adjust the application. Then press
“SELECT” to confirm the selection. The higher the application code figure, the lower
the sensitivity! (!For user convenient operation, we have particularly simplified the
Application to 6 total, which could meet all general markets requirements!)
11. Press “SELECT”, enter Volume-Level adjustment, and press “SETUP”
show“yL-H”, means high volume, press “SETUP”again, show “yL-L”means low
volume.
12. Press “SELECT”, will show “Id-xx”, means entered Device “ID”adjustment
option, “xx”means the device ID code. (Press “ENTER”for one time can add “1” in
single digits, press “SETUP”for one time can add “1” in 10-digit. Press
“ENTER””SETUP”for more times will add more respectively!)
13. Press “SELECT”, will show “A18”. Press “ENTER” then come to “Inspection
Mode” and device ready to work.
14. The device will automatically display PASS COUNT & ALARM COUNT, the
number of memories is 99999, press “RESET”can recount.
33 Zone Walk Through Metal Detector
1. Long press “SELECT”3 seconds, entering“P-0”or ”P-1”mode. (“P-0” for
Inspection, “P-1” for Test Flying Object or Test Mode.) Adjust to “P-0” mode and
press “ENTER”to confirm entering P-0 mode.
2. Long press“SETUP” entering“Frenquency Adjustment”,will show “F-xx”.
“xx”means Device Frequency Code. Press “SELECT” can adjust the Frequency. Press
“ENTER” confirm the selection.In order to avoid signal interference, the frequency
code of each adjacent device must be different. (For user convenient operation, we
have particularly simplified the Frequencies to 16 total, which can for unlimited
devices installation!)
3. Press “SELECT”, will show “12345”, which is factory original password. If have
changed the original password, please input the new correct password. (For password
input details please refer to “Password Management”)
4. Press “ENTER” again, will show “00000”, means password correct can go to next
setting. Or if show “E0000”, means password wrong, need input the correct password
then can go to the next setting.
