Polaroid Macro 5 SLR, Repair Manual

Page: 62 / 83

Repair Manual Macro 5 SLR Camera
62
Encoder Plate and PC Board
1. Removal (Figure 5-12 and 5-12a)
a. Remove the left/right cover assembly as explained on page 39.
b. Rotate the turret assembly to its 3x position to expose one of the screws
that secures the encoder plate to the lower turret plate.
c. Using a torx driver, remove the screw.
d. Rotate the turret assembly to its 1x position to expose the other screw that
secures the encoder plate to the lower turret plate.
e. Using a torx driver, remove the screw.
f. Gently slide out the encoder plate being careful not to break any of its
plastic sensor fingers.
g. Disconnect electrical cable from J24 on the logic PC board at rear of
camera.
h. Using a small flat screwdriver, gently pry up the front end of the encoder
PC board to release it from its support pins and then slide it out from its
support rails (Figure 5-12a).
Figure 5-12 Encoder Plate and Lower Turret Plate
Encoder Plate
Lower Turret
Plate