Polaris W Series, Installation And User Manual

Page: 13 / 196

12
2.5 I Removing the cleaner from the water
• To prevent damaging the equipment, use only the handle to remove the appliance from the
pool.
2.5.1 Automati c "LIFT SYSTEM" mode
The "Lift System" functi on was designed to facilitate removing the cleaner from the water. It may be acti vated at any
ti me, during or at the end of a cleaning cycle.
• If necessary, point the cleaner at the desired wall by pressing and holding the butt on, the cleaner pivots.
When facing the right wall, release the butt on. The cleaner moves towards the wall (see fi gure ) .
• Or simply press and release the butt on to move the cleaner forwards towards the wall in front of it (see
fi gure ).
• It climbs the wall and stays at the waterline (see fi gure ).
• Use the handle to take it out of the water. The cleaner expels water through a rear jet to make it lighter (see fi gure ).
00'60''
2.5.2 Manually
• Switch off the appliance by pressing .
• Bring the cleaner to the edge of the pool by gently pulling on the fl oati ng cable.
• When possible, pick up the cleaner by the handle and lift it gently out of the pool so that the water it contains drains
into the pool (see fi gure and ) .
EN