Polaris 2008 ranger 700 xp, Service Manual

Page: 294 / 330

10.11
ELECTRICAL
10
5. Any blink code numbers stored in the EFI module will
display, one at a time, on the screen.
Example below shows a Blink Code of “42”.
6. The number “61” and/or the word “End” displays after all
codes have been transmitted.
Instrument Cluster Removal
NOTE: Do not allow alcohol or petroleum products
to come in contact with the instrument cluster lens.
1. Lift the hood and disconnect the wire connectors from the
back side of the instrument cluster.
2. Push the instrument cluster out from the back side of the
dash panel, while securely holding the panel and rubber
mount.
NOTE: Do not remove the rubber mount from the
dash panel. Only remove the rubber mount if
necessary. The bezel is a snap-on assembly and is a
serviceable part.
Instrument Cluster Installation
1. Spray a soap and water mixture onto the outer surface area
of the instrument cluster. This will help the instrument
cluster slide into the rubber mount more easily.
2. Be sure the rubber mount inside the pod is fully installed
and that the indexing key on the rubber mount is lined up
with the keyway in the dash panel.
3. Hold the dash panel securely and insert the instrument
cluster into the dash panel. Twist the instrument cluster
gently in a clockwise motion to properly seat the instrument
cluster into the pod assembly. Apply pressure on the bezel
while pressing down on the instrument cluster.
Rubber Mount
Instrument Cluster
Bezel
Push Instrument
Cluster Outward
Dash Panel