Polaris 2008 ranger 700 xp, Service Manual

Page: 163 / 330

6.6
CLUTCHING
9. Use the Driven Clutch Puller (PN 2870913), (C) if
necessary.
10. Remove driven clutch offset spacers from the transmission
input shaft.
11. Remove screws and retainer plate.
12. Remove inner cover retaining bolts at rear of cover.
13. Remove cover along with foam seal on back of cover or
shaft.
Assembly
1. Inspect PVT inner cover-to engine seal. Replace if cracked
or damaged.
2. Place a new foam seal on transmission input shaft.
3. Apply RTV silicone sealant to outside edge of inner cover-
to-engine seal, to ensure a water tight fit between the seal
and the cover. Surfaces must be clean to ensure adhesion
of silicone sealant.
4. Reinstall cover and tighten rear cover bolts just enough to
hold it in place.
5. Fit lip of inner cover seal (A) to engine. Install seal retainer
plate and tighten screws securely.
6. Torque rear inner cover bolts (B) to specification.
7. Install clutch offset spacers on transmission input shaft.
C
Driven Clutch Puller (PN 2870913)
Keep Spacer(s) In Order
Apply RTV Silicone Here
B
C
A
Seal outer edge to cover
with RTV silicone sealant
Offset Spacer(s)