50
51
...ANOTHER CYCLIST IS CAUSING INTERFERENCE?
To avoid cross-talk from another cyclist with a XTrainer Plus, keep the
distance of at least 70 cm / 2'4" between your Receiver mounted on your
Polar Bike Mount and the Polar Speed sensor of the another cyclist.
...I AM CAUSING INTERFERENCE TO OTHER CYCLISTS?
You may cause cross-talk to other cyclocomputers or heart rate
monitors. To avoid this, keep a distance of at least 70 cm / 2'4" between your
Speed sensor and other person's cyclocomputers and a distance of at least
1 meter / 3'4" between your Polar Coded Transmitter and other
cyclocomputers.
...THE SPEED SENSOR STOPS FLASHING?
The red flash of the Speed sensor is only a checking procedure and the
flashing does not continue after 50 flashes when cycling. If you like to check
this procedure again, you must have a pause of 3 minutes during which the
magnet may not pass the Speed Sensor.
...THE DISPLAY IS BLANK OR FADING?
Have the batteries checked. See
Service
.
POLAR GLOSSARY
POLAR GLOSSARY
This symbol indicates coded transmission of heart rate. The inner heart
flashes at the pace of your heart.
In the TIME mode indicates that the alarm is on. In the
MEASURE mode indicates that the sound signal to alarm if you are
exercising below or above your target heart rate zone is on.
- -
When starting the heart rate measurement, these flashing lines indicate
the search for coded transmission.
This symbol indicates, that you are setting the Cycling mode functions
or you are exercising in Cycling mode. In Time mode it indicates that your
most recent exercise was done in Cycling mode.
Alm:
ALARM mode
Altimeter, ALT:
The separate Polar Altitude Sensor measures the altitude
by using atmospheric pressure sensor. The air pressure changes constantly
due to various weather conditions and thus the altitude of a certain place
may differ. Therefore it is recommended to reset the altitude whenever a
reliable reference, for example a peak pointer or a map is available. It is also
recommended to check the altitude of your house and other common
starting points for training.
AM/PM:
12 hour mode of TIME
Chrono:
Displays the total exercising time during the heart rate
measurement
COM:
Indicates the file transferring to the PC. A separate Polar Interface
Plus is required.
Summary of Contents for Xtrainer Plus
Page 36: ...65...
