9. The last
representing single seconds
flashes now. Again, use
the SELECT button
to move up,
or
the SIGNAL/LIGHT button
to move down.
10 When the correct digit
IS
displayed,
press
the STORE/LAP button
to lock in your
selection.
You have now set the Timer and the
digit flashes again At this point, you can
access Timer 2 by pressing
the SET/START/
STOP button.
The phrase TIME 2
appear
on the
If you wish to program the
2, repeat steps 3. through 10.
12. In case you do not wish to program Timer 2.
simply press
t h e S E T / S T A R T / S T O P
button
to
this function. The LIM function
starts flashing Proceed to step 3 on the next
page to set your personal target heart rate
zone.
Note. As you have set Timer 1 and
2
according to instructions, Timer 1
start at the
same time you start the stopwatch You
hear
one beep when the time of
1 up. Timer
2
start
after the beep You
hear two beeps when the time of Timer 2 is up
The timers
you stop the stop-
watch.
S T E P - B Y - S T E P I N S T R U C T I O N S
F O R S E T T I N G T A R G E T H E A R T
R A T E Z O N E L I M I T S
In the time of day mode,
press SELECT
button
three times. SET will appear on the
program status line (bottom of the display), and
the display will cycle through automatically
LIM
Recovery and Time Display
Mode, the latter
either by text
(splits) or TIME (time of day).
2. At any
you can press
the
START/STOP button,
and the option LIM will
lock on the
while the first
of the
upper heart rate target zone limit starts flashing.
Summary of Contents for Accurex NV
Page 19: ......
