User manual HANDY TERMINAL
53
10.4.
ActiveSync Communication
To synchronize, ActiveSync 4.1 or higher must be installed and configured for the appropriate
communication type on the host workstation and the Handy Terminal. Handy Terminals ship with
ActiveSync already installed. Therefore, if ActiveSync is already installed on the host workstation,
you just need to connect the Handy Terminal to the host workstation (via Handy Terminal
peripheral) to initiate communication.
☞
☞
☞
☞
NOTE:
You can download the most current version of ActiveSync (for Windows XP) or Windows Mobile Device
Center (Windows Vista, 7) from
www.microsoft.com
.
WARNING:
When communicating via ActiveSync, your terminal is designed to be connected to the host
workstation with a Toshiba_Tec communication peripheral. We recommend use of Toshiba Tec peripherals, power
cables, and power adapters. Use of any non-Toshiba Tec peripherals, cables, or power adapters may cause
damage not covered by the warranty.
10.5.
Communication Type
The HANDY TERMINAL supports the following type of communication via ActiveSync through its I/O
connector on the bottom panel:
USB
The USB cable and hardware peripherals allow the Handy Terminal to communicate with a
workstation through a USB port or to a network through a USB hub. The Handy Terminal supports
full-speed USB communication (USB 2.0); maximum data transfer rate is 12 Mbps. The Handy
Terminal defaults to USB communication out of the box.
10.6.
Hardware Requirements for Setup
• AC Adaptor (if needed)
• USB ActiveSync Cable (for USB communication)
• ActiveSync v4.1 or higher(for Windows XP), Windows Mobile Device Center(for Vista and Windows
7) installed on the host workstation
• Windows XP, Windows Vista, Windows 7 computer.
10.7.
Software Requirements for Communication
Summary of Contents for HT-K10-SC
Page 1: ......
Page 66: ...User manual HANDY TERMINAL 65...
