- 13 -
2000_DE_Anbau_293
EN
ATTACHING TO TRACTOR
1. Couple the hitching device on the tractor:
CAUTION
Risk of injury by crushing the fingers.
•
Pay attention to the lower link bar when
uncoupling the lower link.
- Switch off PTO shaft
- Attach headstock on the lower linkage of the tractor
- Secure coupling pins correctly
- Position chassis frame horizontally
- The lower linkage limitation chains and/or stabilisers
are to be adjusted so that the attached machine
cannot move sideways.
2. Fold up support stand
CAUTION
Risk of injury from improperly mounted
machine.
•
The machine may fall to the ground
when the support leg is removed.
Check that the implement and tractor
are properly connected.
- loosen the locking pin (1)
- Fold up the support stand
CAUTION
Risk of injury through raised support stand
•
Mind the self-opening support stand
when unlocking it.
-The locking pin (1) engages automatically in the end
position
- Check locking mechanism: Check on the opposite
side whether the locking pin is engaged.
1
3. Make electrical connections
Lighting
- Connect 7-pin plug to tractor (E3)
- Check that the lighting functions on the machine
4. Connect hydraulics
- Switch pto off before connecting
- Move lever of tractor's control unit to floating position
(0)
- Ensure clean plug connections
- Connect hydraulic hoses
- Lay rope into tractor cabin
5. Fit cardan shaft
Important!
Always couple the wide-angle link to tractor
- not to machine!
- Turn engine off and remove ignition key.
- Before fitting the cardan shaft, clean and grease the
machine's connection profiles and the pto.
-To start, fit the cardan shaft with the freewheel on the
machine. Then attach cardan shaft to the tractor pto.
- Secure the protective tubes of all cardan shafts
against rotating by attaching the securing chains.
NOTE
Material damage {29 when cardan shaft length
is unadapted
•
Before initial operation or when chang-
ing the tractor, check the length of the
cardan shaft and adapt if necessary.
•
See chapter "Adapting the Cardan
shaft" in Appendix B.
025-05-04
L2
